Panels · Sheet metal · Insulation · Accessories

NEXLER Penetrator G7 bituminous primer for roofing membranes, 20 L

90,31 € incl. VAT

In stock

Fast-drying, solvent-based, SBS-modified bituminous primer for torch-applied and self-adhesive bituminous membranes, and for mineral substrates beneath solvent-based bituminous coatings.

Indicative consumption when priming: 0.15 L/m². Actual usage depends on substrate absorbency.

Air and substrate temperature: 0 to +30 °C. Approximate drying time: 30 minutes, depending on the substrate and conditions.

Ready to use. Apply with a paintbrush or roofing brush as specified in the technical data sheet. Allow the primer to dry before proceeding.

Price per 20 L container.

In stock

SKU: ecoprofil-9142 Category:

Description

NEXLER Penetrator G7 beneath bituminous membranes

Penetrator G7 prepares the substrate for the specified bituminous layer. List G7 separately from the membrane or compound that will form the waterproofing.

Read the sequence of layers from the substrate outwards. Check whether the design specifies a self-adhesive membrane, a torch-on membrane or a solvent-based compound on a mineral substrate.

Measure the area that will actually receive primer. Calculate laps and cuts separately for the membrane because they affect the roll quantity to purchase.

Primer consumption in the data sheet is an estimate. Sections with different absorbency can take up different quantities over the same area.

Mark where the substrate changes. Do not automatically apply the guidance for concrete or an existing bituminous surface to that section.

Allow a drying interval after applying the primer. Check the actual condition of the surface on site before covering it.

In the handover record, distinguish between completed priming and completed waterproofing. This matters when different crews take over the work.

Waterproofing in the SteelProfil catalogue

What our customers say

Back to top