Powerdeck F on a flat roof: how to check the fleece-facing bond
PIR insulation
Start a Recticel Powerdeck F specification with the roof covering: identify the membrane, attachment method and substrate it requires. The board has a fleece facing, so a foil-faced board of similar thickness is not automatically interchangeable. For a bonded system, confirm compatibility of the precise membrane, adhesive and board surface. Size the insulation separately using λD 0.026 W/(m·K). Check a parapet section for enough space to terminate the waterproofing at the finished level.

Where the board fits in the project
Distinguish the board-to-deck joint from the membrane-to-board joint. A method approved for one interface need not suit the other.
Look for the exact Powerdeck F variant in the documentation. “PIR board” alone does not identify the surface to which the membrane will bond.
Details to agree with the installer
Straight edges and rebates are available. Ask the supplier to confirm the specific edge, size and thickness combination ordered.
Inspect board edges on delivery before spreading adhesive. Show any facing damage or uneven joints to the installer before the surface is covered.
Reading the thermal figures
Use 0.026, not the 0.022 W/(m·K) of some other boards, when calculating Powerdeck F resistance. The result differs even at identical thickness.
Compare quotes at the same thermal resistance, then compare the resulting build-up heights. That reveals the effect of substitution on flashings.
Protecting the layers and their junctions
Check the membrane instructions for substrate cleanliness and moisture. Wet or contaminated fleece needs assessment before work continues.
“Bituminous” or “polyurethane” on the adhesive is not proof of compatibility. Keep the approved system sheet and the product identification used on site.
What to check beyond conductivity
Powerdeck F has compression designation CS(10/Y)120. Reaction-to-fire class E is stated for board thicknesses of 40 mm and above.
B-s2,d0 concerns a particular end use. If the supporting deck or attachment changes, check the classification conditions before adopting that result.
Comparing the full scope of quotes
Include substrate preparation, attachment materials and penetration details in the breakdown. The price of the board does not cover them.
Keep an as-built layer schedule at handover. Future repairs can then be matched to the installed membrane as well as the named insulation.
Free quote
What to include in your enquiry
Tell us how you plan to use the material, the dimensions and the quantity you need. Include the thickness, grade or variant name, along with the delivery town or your preferred collection branch. For a specific product, add its name or a link to the product page. We will reply to the email address you provide to discuss availability and the terms of your order.
More from the building guide
Start a farm insulation survey by marking the spaces that need different conditions on a floor plan. In a vegetable store, air…
Several packs on the lorry may look alike without containing the same board. When insulation arrives, check the product designation and intended…
PIR insulation is not invariably half as thick as EPS. The equivalent thickness depends on the thermal conductivity of both chosen products.…
Assess a year-round timber home as a complete dwelling rather than only walls and a roof. In Poland, the route to construction…
Select PIR roof panels for livestock buildings, stores or wash-down rooms according to conditions on both sides of the roof. Core thickness…
Before installing swissporPIR Alu on a flat roof, establish the deck, falls and fixing method. The manufacturer requires mechanical fixings even where…
Replacing the covering on a house with a finished loft gives access to the rafters from outside. An over-rafter layer of swissporPIR…
A roof over an enclosed, heated swimming pool must suit the actual moisture and chemical conditions inside. Insulation thickness or the label…












