swissporPIR Alu edges: square, rebated or tongue and groove?
PIR insulation
When choosing swissporPIR Alu, look at a section through two joined boards. FIT/GK has square edges, LAP/SF forms a rebated joint, and a TAG/NuF tongue fits into the neighbouring groove. The difference matters in the last row: trimming a board against a wall can remove the factory edge you need for the next joint. Check the laying direction, cuts and coverage before ordering. A shaped edge helps the boards fit together; the design must still provide support and waterproofing.

Read the edge code on the pack
Sketch the butt joint, step or tongue and groove on the order drawing. Resolve any difference between sketch and pack label before laying out the boards.
What the conductivity figure leaves out
The declared core conductivity is 0.022 W/(m·K). It describes heat conduction through the material, not heat passing beside a poorly fitting edge.
Inspect the underside of a trial joint as well. A rebate can look closed from above while a damaged section prevents the boards from sitting level.
Where to put a cut edge
Mark the wall side on the board face before cutting. Keep the factory profile on the side facing the next course where the layout calls for it.
Brush off loose particles and trial-fit without forcing the piece. A cut joint beside a service penetration must follow that penetration detail.
Offset joints between layers
Use different colours for the joints in the two layers. Mark the shorter starter board that moves the upper joint clear of the lower one.
Between closely spaced openings, check the stagger against site dimensions. A diagram of a typical bay does not locate the last cut piece.
Support beneath the joint
The tongue guides the row; it does not turn PIR insulation into a structural member spanning a void. Support is determined by the build-up.
If the joint moves during a trial fit, inspect the substrate and edge. Hammering the tongue home can hide the cause and damage the profile.
Specify the edge in the quotation
Compare quotations for the same profile and net coverage. A pack count without a working dimension says little about how many rows can be completed.
Confirm availability of the specified edge at the chosen thickness. If a square edge is proposed instead, revise the joint layout first.
A delivery check with two boards
Take two undamaged edges from a pack marked TAG/NuF and fit them together. If two steps overlap instead of a tongue entering a groove, hold that row and check the delivery against the order.
Free quote
What to include in your enquiry
Tell us how you plan to use the material, the dimensions and the quantity you need. Include the thickness, grade or variant name, along with the delivery town or your preferred collection branch. For a specific product, add its name or a link to the product page. We will reply to the email address you provide to discuss availability and the terms of your order.
More from the building guide
A passive house reduces energy demand through coordinated insulation, airtightness, windows, thermal-bridge detailing and controlled ventilation. Thick roof insulation or a large…
Start a Utherm Roof LE layout at the point where the build-up has least room, often a low access threshold or rooflight…
If a contractor offers a “Kingspan board or equivalent”, start by asking for the full product name and its intended position. Therma…
An energy retrofit carried out in stages requires the junctions between works performed at different times to be designed. A roof renovated…
PIR sandwich panels form a building envelope from metal facings and an insulating core. Wall and roof panels differ in profile, joints…
A north-facing wall is not inherently damp. Problems arise when a cold surface combines with excess indoor moisture or water entering the…
Choose termPIR WS together with the waterproofing and fixing method for the flat roof. The rigid PIR core is faced on both…
A PIR calculator helps compare insulation options, but its result is only as reliable as the data entered. Use the actual masonry,…


















