Powerroof above the rafters: how much roof does one board cover?
PIR insulation
For over-rafter Powerroof insulation, count boards by their covering dimensions, not their transport size. A 2400 × 1200 mm board covers 2380 × 1180 mm once the tongue and groove engage: about 2.81 m² per full board in the main roof area. Valleys, chimneys and windows change the yield. Draw rows and cuts for each slope before ordering. Also check an eaves section: over-rafter insulation preserves loft headroom but changes the level of the covering and its terminations.

Where the board fits in the project
Measure the slope along its surface. The loft’s horizontal plan area is not the pitched roof area and will not give the number of rows.
Mark tongue and groove directions on the layout. A rotated offcut may fit in size but have the wrong edge for the next row.
Details to agree with the installer
One board’s outer rectangle is 2.88 m². Price installed roof area using the effective coverage, then add cutting waste separately.
At valleys and windows, do not assume two triangular offcuts are interchangeable. Have the roofer mark the support at cut edges.
Reading the thermal figures
Powerroof’s declared conductivity is 0.022 W/(m·K). Select thickness for the required resistance, then check the resulting covering level.
Fixings passing through the boards also enter the whole-roof assessment. The value for PIR alone is not the roof U-value.
Moisture and substrate condition
Distinguish the drainage layer from the aluminium facing on the drawing. Water diverted around a window must return to the intended drainage plane.
Agree the eaves sequence and temporary rain protection for the exposed slope. The board joint alone is not temporary roofing.
What to check beyond conductivity
Powerroof lists CS(10/Y)150 and reaction to fire D-s2,d0. One describes compression; the other describes fire behaviour under the classification conditions.
Neither value specifies screw length or spacing. Transmission of dead and wind loads from covering to rafters needs its own fixing design.
Quotation and handover
Itemise net cover, whole boards and layout waste. This makes it easier to check the delivery without opening every pallet.
Price changes to flashings and window work separately. Quotes for identical board counts may cover quite different roof-edge work.
Free quote
What to include in your enquiry
Tell us how you plan to use the material, the dimensions and the quantity you need. Include the thickness, grade or variant name, along with the delivery town or your preferred collection branch. For a specific product, add its name or a link to the product page. We will reply to the email address you provide to discuss availability and the terms of your order.
More from the building guide
In a SIP house the structural wall and part of the insulation arrive together. This makes erection convenient but changes how services…
PIR wall-panel thickness should follow the building's internal temperature, required U-value and support arrangement. Price alone is not a sound selection method…
Effective roof insulation forms a continuous boundary around heated rooms, rather than merely a thick layer across the middle of a slope.…
Before adding IDELCO α-therm SARKING above rafters, draw the eaves with the existing gutter. Raising the covering changes where water leaves the…
Two quotes for cleaning a barn ceiling may cover the same area yet include completely different work. One company will price only…
A large BauderPIR FA board has two relevant dimensions. Transport and storage use the overall 2400 × 1200 mm size. Set out…
A single window reveals much about how IDELCO α-therm WALL fits into a cavity wall. A section below the sill shows where…
To specify Kingspan Therma TT46 tapered boards, trace the water from the high point of the roof to its outlet. Mark the…












