BauderPIR M and MF: how to read a roof insulation quote
PIR insulation
If a roofing quote says only “BauderPIR 100 mm”, ask whether the product is M or MF and request an edge drawing. Both boards have mineral fleece facings on each side, but the edge profile affects the joint layout. For a bonded roof covering, the fleece, adhesive and waterproofing must also suit the proposed system. Before comparing prices, look up the declared thermal resistance for the quoted thickness. Check the roof covering instructions for the required surface preparation and bonding method.

What to settle before delivery
State the board designation, thickness and edge type on the order. If the supplier proposes a substitute, give the roofer the new facing specification and the exact adhesive specified for the roof covering.
Identifying the board and its declared properties
The M/MF range has a 1200 × 600 mm format. The Polish M sheet gives λD 0.026 W/(m·K) for thicknesses from 80 mm up to but excluding 120 mm, a compression value of at least 120 kPa and reaction to fire class E. Look up the relevant row for any other thickness.
Using a worked example
For a 100 mm M board, dividing 0.10 m by 0.026 W/(m·K) gives roughly 3.85 m²K/W. This illustrates the resistance of one layer. Also check the quote against the declared RD for that thickness.
The roof designer also accounts for the other layers and the fixing method when calculating whole-roof performance. Borrowing a conductivity of 0.022 from an aluminium-faced board would change the result even at the same thickness.
Comparing the available options
Draw two adjacent courses for each option, one layout for M and another for MF. Mark cut edges at the parapet and how the final course closes. This gives the roofer a basis for pricing labour for either edge profile.
Inspection before covering
At delivery, inspect the fleece on the underside as well as on top. Set aside wet boards or boards with detached facings for assessment. Before bonding, check the surface condition against the selected system instructions.
What the quote should cover
Compare quotes for the same roof area and bonding scope. Itemise insulation, substrate preparation, system adhesive and labour at flashings so the difference in cost per square metre can be traced.
Records to keep after completion
Keep the pack label showing M or MF, the sheet for the installed thickness and the name of the adhesive actually used. A photograph of the first joined boards records the joints before concealment.
Free quote
What to include in your enquiry
Tell us how you plan to use the material, the dimensions and the quantity you need. Include the thickness, grade or variant name, along with the delivery town or your preferred collection branch. For a specific product, add its name or a link to the product page. We will reply to the email address you provide to discuss availability and the terms of your order.
More from the building guide
Mark the finished floor level in each room before laying Utherm Floor LE. Work down from that line through tile or timber,…
PIR insulation is not invariably half as thick as EPS. The equivalent thickness depends on the thermal conductivity of both chosen products.…
Mark the intended insulation position on a section through the roof. Between uneven rafters, the material must fill each bay closely. Above…
Above the rafters, Thermano Roof preserves headroom but raises the covering in relation to the eaves, chimney and roof windows. Before choosing…
Before ordering Thermano Deck, establish how the roof will drain, which deck supports it and how the waterproofing will be fixed. The…
A calculator can quickly produce a wall's U-value, but it cannot inspect the masonry, check airtight junctions or identify every moisture risk…
If a roof quote replaces foil-faced PIR with IKO enertherm MG, ask for a revised section and membrane fixing instructions. MG has…
Two insulation quotations may cover the same part of a house while including different quantities and delivery arrangements. When comparing PIR, EPS,…









