Choose a material

Roofing sheets

Blachy trapezowe

Sandwich panels

Płyty warstwowe

PIR insulation boards

Płyty izolacyjne PIR

XPS

Izolacja XPS

Accessories

Akcesoria montażowe

Fencing

Sztachety metalowe

Choosing IKO enertherm ALU for a house: board designation and assembly details

PIR insulation

At a glance

When choosing IKO enertherm ALU for a house, first establish where the board sits in the assembly and which layers protect it. The aluminium facing helps identify the product family, but the full label identifies the variant being ordered. Use the figures for the chosen thickness in thermal calculations. For reaction to fire, read the classification conditions, particularly the substrate and method of installation. A rating for a specified assembly on steel decking cannot be transferred to a timber assembly simply because the insulation boards look similar.

IKO enertherm ALU boards with aluminium facings and a cream-coloured PIR core

What to settle before delivery

The delivery note and drawings should identify the same product. Request the complete ALU or ALU TG designation, thickness and joint profile. A joint detail shows whether the supplied edge suits the intended laying sequence.

Identifying the board and its declared properties

The PIR core of IKO enertherm ALU has over 95% closed cells and aluminium facings on both sides. The documentation gives λD 0.022 W/(m·K) and at least 175 kPa at 10% deformation. Check the support design separately for the intended loads.

Using a worked example

Take a 100 mm ALU layer. Dividing 0.10 m by 0.022 W/(m·K) gives approximately 4.55 m²K/W. For comparison with the product sheet, find the 100 mm entry and its declared resistance RD.

Whether a wall or roof meets its target U-value also depends on the other layers and junctions. Ask for the section to show where the insulation meets frames, rafters or fixings.

Comparing the available options

Reaction to fire class F is stated for the product itself. B-s2,d0 applies to the specified end use on a steel substrate. If the substrate, protective lining or installation method changes, ask for classification evidence covering the revised assembly.

Inspection before covering

Before closing the assembly, check the joints and continuity of protective layers at reveals and service penetrations. Mark any site changes on the section and agree the next steps with the designer.

What the quote should cover

Compare prices for the same ALU variant and thickness. Add differences in fixings, cutting and the room-side protective lining to any difference in board price. This compares the cost of two completed assemblies.

Records to keep after completion

At handover, collect the batch reference, declaration of performance and a section showing the installed layers. Include the document supporting the fire assessment for the actual assembly so later alterations can be reviewed.

7 branches. Materials closer to your project.

  • SEROCK — Dzierżenin 34 E [mapa]
  • BŁONIE — ul. Sochaczewska 138A [mapa]
  • RADOM — ul. Grobickiego 8 [mapa]
  • ŁÓDŹ — Natolin 8 [mapa]
  • OLSZTYN — Barczewo, ul. Prosta 9 [mapa]
  • WROCŁAW — ul. Jerzmanowska 10C [mapa]
  • GORZÓW WLKP. — ul. Zielona 33/34 [mapa]
Budowlanka.org — map

Free quote

What to include in your enquiry

Tell us how you plan to use the material, the dimensions and the quantity you need. Include the thickness, grade or variant name, along with the delivery town or your preferred collection branch. For a specific product, add its name or a link to the product page. We will reply to the email address you provide to discuss availability and the terms of your order.

More from the building guide