IKO enertherm ALU TG: planning tongue-and-groove joints and cut edges
PIR insulation
On IKO enertherm ALU TG boards, the tongue of one board fits into the groove of the next. Along a straight run it is easy to see whether the edges engage. At a wall, column or recess, cutting removes part of the profile. Before ordering, draw the first and last courses and mark which edges will retain their factory profile. Include the support and finish for cut pieces. The drawing gives a basis for estimating quantities and shows where the installer must maintain continuity in the next layer.

What to settle before delivery
Measure both ends of the final strip from a common reference corner. Different readings mean the closing piece will taper. Allow for this when setting the width of the first course.
Identifying the board and its declared properties
The board has an aluminium laminate and a PIR core with λD of 0.022 W/(m·K). The manufacturer gives a compression value of at least 175 kPa and reaction to fire class F for the product. B-s2,d0 applies under the specified end-use conditions.
Using a worked example
For example, 100 mm of insulation at this conductivity gives about 4.55 m²K/W from 0.100 / 0.022. Record the declared RD for the thickness purchased.
The resistance describes heat flow through the field of the board. At a cut edge, close the joint to the specified detail and maintain the continuity of the required sealing layers.
Comparing the available options
Compare starting with a full board against trimming the first strip to leave a wider closing piece. Count separately any offcuts whose plain edge can be reused against another wall.
Inspection before covering
Check a trial joint along its full length. If an edge stands proud or the board rocks under hand pressure, inspect the profile and substrate before fitting the next course.
What the quote should cover
Price the ALU TG boards, cutting and perimeter materials separately. Tongue and groove align the joints. Allow separately for waterproofing and fixings wherever the design requires them.
Records to keep after completion
Photograph the closing strip and its termination before the next layer covers it. Recording the laying direction helps locate joints later without exposing the entire area.
Free quote
What to include in your enquiry
Tell us how you plan to use the material, the dimensions and the quantity you need. Include the thickness, grade or variant name, along with the delivery town or your preferred collection branch. For a specific product, add its name or a link to the product page. We will reply to the email address you provide to discuss availability and the terms of your order.
More from the building guide
When a puddle forms beside a rooflight, survey the levels between its kerb and the outlet first. They show whether the kerb…
Internal insulation can be considered when an older masonry building's facade must remain unchanged. Its suitability depends on the existing construction: thick…
Three layers meet a rooflight kerb. EFYOS BLUE A insulation must reach it as shown on the thermal detail. The vapour control…
Schedule IKO enertherm ALU TAP from the outlet towards the high edge of each drainage area. Two tapers can have the same…
A passive house reduces energy demand through coordinated insulation, airtightness, windows, thermal-bridge detailing and controlled ventilation. Thick roof insulation or a large…
Choose the wall finish before choosing PIR. A rendered external insulation system, a ventilated façade and a cavity wall use different interfaces…
Effective roof insulation forms a continuous boundary around heated rooms, rather than merely a thick layer across the middle of a slope.…
Utherm Roof BM has two different surfaces: bituminised glass fleece on one side and mineralised glass fleece on the other. When ordering…


















