Thermano GK-A or GK-H2: choosing an internal lining by room
PIR insulation
Thermano GK-A and GK-H2 combine a PIR core with 12.5 mm plasterboard. White type A is for ordinary dry rooms; green H2 has reduced water absorption. Choose by how the particular wall is used. A shower splash zone needs different protection from a surface outside the spray. Assess the masonry before buying: internal insulation changes its temperature and drying potential. The colour of the lining does not tell you whether a damp wall can be covered.

Where the board fits in the project
Mark dry, occasionally humid and directly wetted surfaces on the room plan. Use that map to select both lining and finish.
In wet areas, ask the installer to show how the seal continues around taps, pipes and corners. Green plasterboard does not waterproof the wall beneath tiles.
Junctions worth checking
Set out the 1200 × 2600 mm BASIC-edge panels on a wall elevation. Mark door frames and electrical boxes before cutting openings.
Check how much room the finished panel takes beside the hinge. A narrow plasterboard strip is easier to revise on paper than after fitting the frame.
Choosing the thickness for your home
Compare declared thermal resistances for the finished GK variants at their total thicknesses. List PIR thickness separately from the fixed 12.5 mm plasterboard.
Measure the finished room width if lining opposite walls. A small thickness change can determine whether an existing wardrobe will fit.
Moisture and substrate condition
Investigate damp marks at the skirting or reveals before bonding panels. Covering the area makes later inspection harder.
Agree with the designer how insulation meets the ceiling and partitions. Filling the visible plasterboard joint does not resolve a thermal bridge.
Understanding load and fire ratings
For GK-A and GK-H2, B-s1,d0 is stated from the plasterboard side under the classification conditions. It applies neither to an exposed core nor to the wall’s fire resistance period.
Locate basin, cabinet and rail fixings before closing the wall. The fixing detail should identify the load-bearing substrate and the route through the lining.
Comparing the full scope of quotes
List GK-A, GK-H2 and waterproofed areas separately in the quote so that costs remain comparable across different room layouts.
At handover, inspect corners, sockets and frame junctions. Keep pre-tiling photos of the seals alongside the panel specification.
Free quote
What to include in your enquiry
Tell us how you plan to use the material, the dimensions and the quantity you need. Include the thickness, grade or variant name, along with the delivery town or your preferred collection branch. For a specific product, add its name or a link to the product page. We will reply to the email address you provide to discuss availability and the terms of your order.
More from the building guide
To assess BauderPIR FA-TE for a terrace above a heated room, draw a section from the door threshold to the outlet. Allow…
A roof over an enclosed, heated swimming pool must suit the actual moisture and chemical conditions inside. Insulation thickness or the label…
Attic insulation works when it forms a continuous layer and the entire roof manages moisture and air leakage. A thicker board cannot…
The amount of waste when insulating with PIR boards also depends on measurement, the layout of elements and the organisation of delivery.…
Assess thinner internal insulation by comparing two complete solutions that meet the required performance. PIR’s low thermal conductivity can reduce insulation thickness,…
Effective roof insulation forms a continuous boundary around heated rooms, rather than merely a thick layer across the middle of a slope.…
To decide whether an existing sill will work with SOPREMA EFIGREEN ITE, measure its projection from the future façade face. On a…
For a roof with several rooflights, order Therma TR26 from a plan showing the kerb dimensions. Total roof area misses the short…














